diff --git a/docs/rockpi4.md b/docs/rockpi4.md new file mode 100644 index 0000000..5a617aa --- /dev/null +++ b/docs/rockpi4.md @@ -0,0 +1,63 @@ +Rock Pi 4 A/B Single Board Computer {#_rockpi} +============================= + +ROCK Pi 4 is a Rockchip RK3399 based SBC(Single Board Computer) by Radxa. It can run android or some Linux distributions. ROCK Pi 4 features a six core ARM processor, 64bit dual channel 3200Mb/s LPDDR4, up to 4K@60 HDMI, MIPI DSI, MIPI CSI, 3.5mm jack with mic, 802.11 ac WIFI, Bluetooth 5.0, USB Port, GbE LAN, 40-pin color expansion header, RTC. Also, ROCK Pi 4 supports USB PD and QC powering. + +ROCK Pi 4 comes in two models, Model A and Model B, each model has 1GB, 2GB or 4GB ram options. for detailed difference of Model A and Model B, please check Specifications. + +Board Support +------------- + +- [ROCK Pi 4](https://wiki.radxa.com/Rockpi4) + +Interface notes +--------------- + +- **UART**: ttyS0 not usable, use ttyS2 and ttyS4 +- UART2 is enabled as U-boot and Linux serial console by default. Check Rockpi4/dev/serial-console to use. Check Rockpi4/hardware/devtree_overlays to disable serial console on UART2. +- UART2 & UART4 support a wide range of baud rate. It includes but not is not limited to the following baud rates. For instance, 115200bps. 500000bps, 1500000bps and so on. +- Function marked with color orange is the default function of this pin. +- Except Pins for power supply, all pins are laid out directly to Soc RK3399. +- For pin 3, 5, 27, 28, 29 and 31, each pin is connected to the 3.0V supply through a 4.7K pull-up resistor. +- Pin 19, 21, 23, 24 are laid out directly to the pins of SPI device on board. +- Pin 7 is laid out directly to the pin of MIPI CSI on board. +- For I2C-2 and I2C-7 +- We have do the test using the i2c device e2prom. We need to open the i2c device file, and then do the read or write operation. + +Pin Mapping +----------- + +PROCK Pi 4 has a 40-pin expansion header. Each pin is distinguished by color. + +|Additional Function | Primary Function| PIN | PIN | Primary Function | Additional Function | +|--------------------|------------------|:------|------:|--------------------|---------------------| +| | +3.3V | 1 | 2 | +5.0V | | +| | I2C7_SDA | 3 | 4 | +5.0V | | +| | I2C7_SCL | 5 | 6 | GND | | +| | SPI2_CLK | 7 | 8 | UART2_TXD | | +| | GND | 9 | 10 | UART2_RXD | | +| | PWM0 | 11 | 12 | I2S1_SCLK | | +| | PWM1 | 13 | 14 | GND | | +| | SPDIF_TX | 15 | 16 | GPIO4_D2 | | +| | +3.3V | 17 | 18 | GPIO4_D4 | | +| UART4_TXD | SPI1_TXD | 19 | 20 | GND | | +| UART4_RXD | SPI1_RXD | 21 | 22 | GPIO4_D5 | | +| | SPI1_CLK | 23 | 24 | SPI1_CSn | | +| | GND | 25 | 26 | ADC_IN0 | | +| | I2C2_SDA | 27 | 28 | I2C2_CLK | | +| I2C6_SCL | SPI2_TXD | 29 | 30 | GND | | +| I2C6_SDA | SPI2_RXD | 31 | 32 | SPDIF_TX | UART3_CTSn | +| | SPI2_CSn | 33 | 34 | GND | | +| | I2S1_LRCK_TX| 35 | 36 | I2S1_LRCK_RX | | +| | GPIO4_D6 | 37 | 38 | I2S1_SDI | | +| | GND | 39 | 40 | I2S1_SDO | | + + +Resources +--------- + +The following links will take you to additional Rock Pi 4 resources + +- [Armbian for Rock Pi 4](https://www.armbian.com/rock-pi-4/) +- [Forums](https://forum.radxa.com/c/rockpi4) +- [Github Repo](https://github.com/radxa)