GT/GrosseTete -> Joule. This commit deprecates the MRAA_INTEL_GT_TUCHUCK
mraa_platform_t value and links the grossetete.md page to joule.md.
Signed-off-by: Wai Lun Poon <wai.lun.poon@intel.com>
Signed-off-by: Brendan Le Foll <brendan.le.foll@intel.com>
Like the beaglebone, the phyBOARD-Wega also got an am335x.
So I merged the four mmap-functions for gpio_context and some
identical defines in a separate header and c-file.
The new platform support-files are based on beaglebone-files.
The documentation of phyBOARD-Wega is still in process,
but for now there are enough informations.
At this time it is possible to use GPIO-Pins and Uart0
(tested via python with mraa). The code for using SPI, I2C and
PWM is also still in process and not tested yet.
Signed-off-by: Norbert Wesp <nwesp@phytec.de>
Signed-off-by: Brendan Le Foll <brendan.le.foll@intel.com>
Enum was deprecated in 0.10.x and causes issues with strict C89 compliance so
is now removed
Signed-off-by: Brendan Le Foll <brendan.le.foll@intel.com>
This commit introduces support for Dallas Semiconductor (DS) 1-wire
compliant device support using an available UART device.
The principle of operation is described in the following Application
note by Maxim Electronics:
https://www.maximintegrated.com/en/app-notes/index.mvp/id/214
with help (1-wire search) from:
https://www.maximintegrated.com/en/app-notes/index.mvp/id/187
It has been tested on Galileo 2 and Edison, with 2 DS 1-wire devices,
the DS18B20 and DS2413 connected to the bus. A UPM driver for the
DS2413 is already complete and a PR will be submitted after this one.
It is important that you use a UART with CMOS/TTL level voltages
(3.3v/5v) RX and TX lines. DO NOT use standard RS232 level voltages
or you are going to have a bad day.
In order for this to work, a simple interface circuit, using a single
diode must be constructed:
(forgive my "Asciihematic" :)
-|
U|
A| TX---|<--+
R| |
T| RX-------o--------o 1-wire data bus
-|
The diode on TX is a 1N4148 (cheap and common), with the cathode
connected to TX, and the anode connected to RX and the 1-wire data
line.
The 1-wire data line requires a pull-up resistor, as the DS 1-wire
spec requires. 4.7-5K is typical for DS 1-wire buses.
NOTE: DHT-type (temp/humidity sensor) 1-wire devices ARE NOT DS 1-wire
compliant, and will not work with this code/circuit unfortunately.
Also note, this will use up one of your UARTs, which cannot be used
for any other purpose (ie: to access true UART-type serial devices).
You can however, connect as many DS 1-wire devices as feasible to this
UART, as it will function as a DS 1-wire bus master.
Signed-off-by: Jon Trulson <jtrulson@ics.com>
Signed-off-by: Brendan Le Foll <brendan.le.foll@intel.com>
To ensure backwards comptability MRAA_ERROR_PLATFORM_ALREADY_INITIALISED
remains as member of mraa_result_t but now has same code as MRAA_SUCCESS
Signed-off-by: Henry Bruce <henry.bruce@intel.com>
