##// END OF EJS Templates
No need to check if the service exists...
No need to check if the service exists If this snippet is included, the service exists

Fichier de la dernière révision:

r501:3c3d6ac60789
r579:90a66357153e
Show More
20-networking.sh
146 lines | 5.4 KiB | application/x-sh | BashLexer
#
# Setup Networking
#
# Load utility functions
. ./functions.sh
# Install and setup hostname
install_readonly files/network/hostname "${ETC_DIR}/hostname"
sed -i "s/^RaspberryPI/${HOSTNAME}/" "${ETC_DIR}/hostname"
# Install and setup hosts
install_readonly files/network/hosts "${ETC_DIR}/hosts"
sed -i "s/RaspberryPI/${HOSTNAME}/" "${ETC_DIR}/hosts"
# Setup hostname entry with static IP
if [ "$NET_ADDRESS" != "" ] ; then
NET_IP=$(echo "${NET_ADDRESS}" | cut -f 1 -d'/')
sed -i "s/^127.0.1.1/${NET_IP}/" "${ETC_DIR}/hosts"
fi
# Remove IPv6 hosts
if [ "$ENABLE_IPV6" = false ] ; then
sed -i -e "/::[1-9]/d" -e "/^$/d" "${ETC_DIR}/hosts"
fi
# Install hint about network configuration
install_readonly files/network/interfaces "${ETC_DIR}/network/interfaces"
# Install configuration for interface eth0
install_readonly files/network/eth.network "${ETC_DIR}/systemd/network/eth.network"
# Install configuration for interface wl*
install_readonly files/network/wlan.network "${ETC_DIR}/systemd/network/wlan.network"
#always with dhcp since wpa_supplicant integration is missing
sed -i -e "s/DHCP=.*/DHCP=yes/" -e "/DHCP/q" "${ETC_DIR}/systemd/network/wlan.network"
if [ "$ENABLE_DHCP" = true ] ; then
# Enable DHCP configuration for interface eth0
sed -i -e "s/DHCP=.*/DHCP=yes/" -e "/DHCP/q" "${ETC_DIR}/systemd/network/eth.network"
# Set DHCP configuration to IPv4 only
if [ "$ENABLE_IPV6" = false ] ; then
sed -i "s/DHCP=.*/DHCP=v4/" "${ETC_DIR}/systemd/network/eth.network"
fi
else # ENABLE_DHCP=false
# Set static network configuration for interface eth0
sed -i\
-e "s|DHCP=.*|DHCP=no|"\
-e "s|Address=\$|Address=${NET_ADDRESS}|"\
-e "s|Gateway=\$|Gateway=${NET_GATEWAY}|"\
-e "0,/DNS=\$/ s|DNS=\$|DNS=${NET_DNS_1}|"\
-e "0,/DNS=\$/ s|DNS=\$|DNS=${NET_DNS_2}|"\
-e "s|Domains=\$|Domains=${NET_DNS_DOMAINS}|"\
-e "0,/NTP=\$/ s|NTP=\$|NTP=${NET_NTP_1}|"\
-e "0,/NTP=\$/ s|NTP=\$|NTP=${NET_NTP_2}|"\
"${ETC_DIR}/systemd/network/eth.network"
if [ "$CRYPTFS_DROPBEAR" = true ] ; then
# Get cdir from NET_ADDRESS e.g. 24
cdir=$(${NET_ADDRESS} | cut -d '/' -f2)
# Convert cdir ro netmask e.g. 24 to 255.255.255.0
NET_MASK=$(cdr2mask "$cdir")
# Write static ip settings to "${ETC_DIR}"/initramfs-tools/initramfs.conf
sed -i "\$aIP=${NET_ADDRESS}::${NET_GATEWAY}:${NET_MASK}:${HOSTNAME}:" "${ETC_DIR}"/initramfs-tools/initramfs.conf
# Regenerate initramfs
chroot_exec mkinitramfs -o "/boot/firmware/initramfs-${KERNEL_VERSION}" "${KERNEL_VERSION}"
fi
fi
# Remove empty settings from network configuration
sed -i "/.*=\$/d" "${ETC_DIR}/systemd/network/eth.network"
# Remove empty settings from wlan configuration
sed -i "/.*=\$/d" "${ETC_DIR}/systemd/network/wlan.network"
# Move systemd network configuration if required by Debian release
mv -v "${ETC_DIR}/systemd/network/eth.network" "${LIB_DIR}/systemd/network/10-eth.network"
# If WLAN is enabled copy wlan configuration too
if [ "$ENABLE_WIRELESS" = true ] ; then
mv -v "${ETC_DIR}/systemd/network/wlan.network" "${LIB_DIR}/systemd/network/11-wlan.network"
fi
rm -fr "${ETC_DIR}/systemd/network"
# Enable systemd-networkd service
chroot_exec systemctl enable systemd-networkd
# Install host.conf resolver configuration
install_readonly files/network/host.conf "${ETC_DIR}/host.conf"
# Enable network stack hardening
if [ "$ENABLE_HARDNET" = true ] ; then
# Install sysctl.d configuration files
install_readonly files/sysctl.d/82-rpi-net-hardening.conf "${ETC_DIR}/sysctl.d/82-rpi-net-hardening.conf"
# Setup resolver warnings about spoofed addresses
sed -i "s/^# spoof warn/spoof warn/" "${ETC_DIR}/host.conf"
fi
# Enable time sync
if [ "$NET_NTP_1" != "" ] ; then
chroot_exec systemctl enable systemd-timesyncd.service
fi
# Download the firmware binary blob required to use the RPi3 wireless interface
if [ "$ENABLE_WIRELESS" = true ] ; then
if [ ! -d "${WLAN_FIRMWARE_DIR}" ] ; then
mkdir -p "${WLAN_FIRMWARE_DIR}"
fi
# Create temporary directory for firmware binary blob
temp_dir=$(as_nobody mktemp -d)
# Fetch firmware binary blob for RPI3B+
if [ "$RPI_MODEL" = 3P ] ; then
# Fetch firmware binary blob for RPi3P
as_nobody wget -q -O "${temp_dir}/brcmfmac43455-sdio.bin" "${WLAN_FIRMWARE_URL}/brcmfmac43455-sdio.bin"
as_nobody wget -q -O "${temp_dir}/brcmfmac43455-sdio.txt" "${WLAN_FIRMWARE_URL}/brcmfmac43455-sdio.txt"
as_nobody wget -q -O "${temp_dir}/brcmfmac43455-sdio.clm_blob" "${WLAN_FIRMWARE_URL}/brcmfmac43455-sdio.clm_blob"
# Move downloaded firmware binary blob
mv "${temp_dir}/brcmfmac43455-sdio."* "${WLAN_FIRMWARE_DIR}/"
# Set permissions of the firmware binary blob
chown root:root "${WLAN_FIRMWARE_DIR}/brcmfmac43455-sdio."*
chmod 600 "${WLAN_FIRMWARE_DIR}/brcmfmac43455-sdio."*
elif [ "$RPI_MODEL" = 3 ] || [ "$RPI_MODEL" = 0 ] ; then
# Fetch firmware binary blob for RPi3
as_nobody wget -q -O "${temp_dir}/brcmfmac43430-sdio.bin" "${WLAN_FIRMWARE_URL}/brcmfmac43430-sdio.bin"
as_nobody wget -q -O "${temp_dir}/brcmfmac43430-sdio.txt" "${WLAN_FIRMWARE_URL}/brcmfmac43430-sdio.txt"
# Move downloaded firmware binary blob
mv "${temp_dir}/brcmfmac43430-sdio."* "${WLAN_FIRMWARE_DIR}/"
# Set permissions of the firmware binary blob
chown root:root "${WLAN_FIRMWARE_DIR}/brcmfmac43430-sdio."*
chmod 600 "${WLAN_FIRMWARE_DIR}/brcmfmac43430-sdio."*
fi
# Remove temporary directory for firmware binary blob
rm -fr "${temp_dir}"
fi