Initial commit

files/boot/config.txt

@@ -0,0 +1,43 @@
+# For more options and information see
+# http://www.raspberrypi.org/documentation/configuration/config-txt.md
+# Some settings may impact device functionality. See link above for details
+
+# uncomment if you get no picture on HDMI for a default "safe" mode
+#hdmi_safe=1
+
+# uncomment this if your display has a black border of unused pixels visible
+# and your display can output without overscan
+#disable_overscan=1
+
+# uncomment the following to adjust overscan. Use positive numbers if console
+# goes off screen, and negative if there is too much border
+#overscan_left=16
+#overscan_right=16
+#overscan_top=16
+#overscan_bottom=16
+
+# uncomment to force a console size. By default it will be display's size minus
+# overscan.
+#framebuffer_width=1280
+#framebuffer_height=720
+
+# uncomment if hdmi display is not detected and composite is being output
+#hdmi_force_hotplug=1
+
+# uncomment to force a specific HDMI mode (this will force VGA)
+#hdmi_group=1
+#hdmi_mode=1
+
+# uncomment to force a HDMI mode rather than DVI. This can make audio work in
+# DMT (computer monitor) modes
+#hdmi_drive=2
+
+# uncomment to increase signal to HDMI, if you have interference, blanking, or
+# no display
+#config_hdmi_boost=4
+
+# uncomment for composite PAL
+#sdtv_mode=2
+
+# uncomment to overclock the arm. 700 MHz is the default.
+#arm_freq=800

files/boot/uboot.mkimage

@@ -0,0 +1,16 @@
+# Set device tree fdtfile
+setenv dtbfile bcm2709-rpi-2-b.dtb
+
+# Tell Linux that it is booting on a Raspberry Pi2/3
+setenv machid 0x00000c42
+
+# Save these changes to u-boot's environment
+saveenv
+
+# Load the existing Linux kernel into RAM
+mmc dev 0
+fatload mmc 0:1 ${kernel_addr_r} kernel7.img
+fatload mmc 0:1 ${fdt_addr_r} ${dtbfile}
+fatload mmc 0:1 ${ramdisk_addr_r} ${initramfs}
+
+# Boot the kernel we have just loaded