dd19634889
The earlier patches did not fix the following issues. 1) gpio number used for ISH I2C 0 and I2C 1 were not correct 2) gpio number used in ISH I2C 1 and I2C 2 were not correct 3) ISH UART 0 gpio numbers were wrong This patch fixes this issue and also update the doc. Signed-off-by: Arun Ravindran <arun.ravindran@intel.com> Signed-off-by: Brendan Le Foll <brendan.le.foll@intel.com>
143 lines
4.9 KiB
Markdown
143 lines
4.9 KiB
Markdown
Intel Joule {#joule}
|
|
===========
|
|
|
|
[http://www.intel.com/joule](http://www.intel.com/joule)
|
|
|
|
The Intel Joule expansion board is supported by Mraa
|
|
|
|
Revision Support
|
|
----------------
|
|
Intel Joule expansion board
|
|
|
|
Interface notes
|
|
---------------
|
|
|
|
**SPI**
|
|
|
|
Two SPI buses are available, with one chipselect each. Pins listed are MRAA
|
|
numbered pins. Other chip selects are available if enabled in BIOS/EEPROM but
|
|
cannot be enabled as BIOS options. You will need the spidev kernel module
|
|
loaded, Ostro-XT does this by default.
|
|
|
|
Bus 0 (32765)
|
|
MOSI = 2
|
|
MISO = 4
|
|
CS = 6
|
|
CLK = 10
|
|
|
|
Bus 1 (32766)
|
|
MOSI = 67
|
|
MISO = 69
|
|
CS0 = 59
|
|
CS1 = 61
|
|
CLK = 65
|
|
|
|
(remove 40 from numbers to get pin header number for pins on low speed header
|
|
2)
|
|
|
|
**UART** Some pins are labelled as UARTs but are not configured in BIOS as UART
|
|
so only available UART is on the FTDI header. Disable the getty on ttyS2 and
|
|
use mraa's uart raw mode to initialise on ttyS2. The Jumper J8 can be used to
|
|
switch between using the FTDI 6 pin header and the micro USB output.
|
|
|
|
Pin Mapping
|
|
-----------
|
|
|
|
The Intel Joule expansion board has two breakouts, breakout #1 is 1-40 whilst breakout2 is 41-80. The
|
|
LEDs are numbered from 100-103.
|
|
|
|
ISH UART are named as: IURT
|
|
ISH I2C are named as:IIC
|
|
|
|
| MRAA Number | Physical Pin | Function |
|
|
|-------------|--------------|----------|
|
|
| 1 | GPIO | GPIO |
|
|
| 2 | SPP1RX | GPIO SPI |
|
|
| 3 | PMICRST | NONE |
|
|
| 4 | SPP1TX | GPIO SPI |
|
|
| 5 | 19.2mhz | GPIO |
|
|
| 6 | SPP1FS0 | GPIO SPI |
|
|
| 7 | UART0TX | GPIO |
|
|
| 8 | SPP1FS2 | GPIO SPI |
|
|
| 9 | PWRGD | NONE |
|
|
| 10 | SPP1CLK | GPIO SPI |
|
|
| 11 | I2C0SDA | I2C |
|
|
| 12 | I2S1SDI | GPIO |
|
|
| 13 | I2C0SCL | I2C |
|
|
| 14 | I2S1SDO | GPIO |
|
|
| 15 | IIC0SDA | I2C |
|
|
| 16 | I2S1WS | GPIO |
|
|
| 17 | IIC0SCL | I2C |
|
|
| 18 | I2S1CLK | GPIO |
|
|
| 19 | IIC1SDA | I2C |
|
|
| 20 | I2S1MCL | GPIO |
|
|
| 21 | IIC1SCL | I2CO |
|
|
| 22 | UART1TX | UART |
|
|
| 23 | I2S4SDO | NONE |
|
|
| 24 | UART1RX | UART |
|
|
| 25 | I2S4SDI | NONE |
|
|
| 26 | PWM0 | GPIO PWM |
|
|
| 27 | I2S4BLK | GPIO |
|
|
| 28 | PWM1 | GPIO PWM |
|
|
| 29 | I2S4WS | NONE |
|
|
| 30 | PWM2 | GPIO PWM |
|
|
| 31 | I2S3SDO | NONE |
|
|
| 32 | PWM3 | GPIO PWM |
|
|
| 33 | I2S3SDI | NONE |
|
|
| 34 | 1.8V | NONE |
|
|
| 35 | I2S4BLK | GPIO |
|
|
| 36 | GND | NONE |
|
|
| 37 | GND | NONE |
|
|
| 38 | GND | NONE |
|
|
| 39 | GND | NONE |
|
|
| 40 | 3.3V | NONE |
|
|
| 41 | GND | NONE |
|
|
| 42 | 5V | NONE |
|
|
| 43 | GND | NONE |
|
|
| 44 | 5V | NONE |
|
|
| 45 | GND | NONE |
|
|
| 46 | 3.3V | NONE |
|
|
| 47 | GND | NONE |
|
|
| 48 | 3.3V | NONE |
|
|
| 49 | GND | NONE |
|
|
| 50 | 1.8V | NONE |
|
|
| 51 | GPIO | GPIO |
|
|
| 52 | 1.8V | NONE |
|
|
| 53 | PANEL | GPIO |
|
|
| 54 | GND | NONE |
|
|
| 55 | PANEL | GPIO |
|
|
| 56 | CAMERA | NONE |
|
|
| 57 | PANEL | GPIO |
|
|
| 58 | CAMERA | NONE |
|
|
| 59 | SPP0FS0 | GPIO SPI |
|
|
| 60 | CAMERA | NONE |
|
|
| 61 | SPP0FS1 | GPIO SPI |
|
|
| 62 | SPI_DAT | SPI |
|
|
| 63 | SPP0FS2 | GPIO SPI |
|
|
| 64 | SPICLKB | GPIO |
|
|
| 65 | SPI0CLK | GPIO SPI |
|
|
| 66 | SPICLKA | GPIO |
|
|
| 67 | SPP0TX | GPIO SPI |
|
|
| 68 | UART0RX | GPIO UART|
|
|
| 69 | SPP0RX | GPIO SPI |
|
|
| 70 | UART0RT | GPIO UART|
|
|
| 71 | I2C1SDA | GPIO I2C |
|
|
| 72 | UART0CT | GPIO UART|
|
|
| 73 | I2C1SCL | GPIO I2C |
|
|
| 74 | IURT0TX | GPIO UART|
|
|
| 75 | I2C2SDA | GPIO I2C |
|
|
| 76 | IURT0RX | GPIO UART|
|
|
| 77 | I2C2SCL | GPIO I2C |
|
|
| 78 | IURT0RT | GPIO UART|
|
|
| 79 | RTC_CLK | GPIO |
|
|
| 80 | IURT0CT | GPIO UART|
|
|
| 100 | LED100 | GPIO |
|
|
| 101 | LED101 | GPIO |
|
|
| 102 | LED102 | GPIO |
|
|
| 103 | LED103 | GPIO |
|
|
| 104 | LEDWIFI | GPIO |
|
|
| 105 | LEDBT | GPIO |
|
|
|
|
To see a live pin mapping use the command:
|
|
$ mraa-gpio list
|